Interested to Buy Any Domain ? << Click Here >> for more details...
WHY 6.6KV MOTORS ARE STAR CONNECTED AND WHY NOT DELTA CONNECTED,
- 15 Answers
- 35108 Views
- Bhel, I also Faced
- E-Mail Answers
Answer Posted / mayur
FOLLOWING MAY BE THE REASON.
1. REDUCE THE STARTING CURRENT
JUST LIKE STAR / DELTA STARTER USED FOR CERTAIN MOTORS TO REDUCE THE STARTING CURRENT. THE APPLIED VOLTAGE ACROSS THE WINDING IN CASE OF DELTA CONNECTED MOTOR IS 1.73 TIMES THE STAR CONNECTED MOTOR. HENCE IN STAR CONNECTED MOTOR THERE IS A REDUCED VOLTAGE STARTING. SUBSEQUENTLY CURRENT IS ALSO REDUCED, HOWEVER THERE IS A SMALL EFFECT ON THE STARTING TORQUE SINCE TORQUE IS PROPORTIONAL TO SQUARE OF THE CURRENT WHICH MAY BE ACCEPTABLE.
ALSO SINCE LESS VOLTAGE IS APPLIED, THE INSULATION REQUIRED FOR HT MOTORS MAY ALSO REDUCE LEADING TO COST SAVING.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Pl.brief me about Electrical power distribution system from Main generating station to Industry.What is the use of in between station.
Define conversion efficiency of a power amplifier.
Damping resistor provided in open delta (tartiary) winding of a measuring PT at the incoming of a MV inverter drive panel is getting heated up. Can any body explain the reasons and suggest the remedy?
What is the breaking capacity of transformer and how can we calculate the breaking capacity of tranformer
How to protect a Dosing pumps/any sensitive equipment (single phase) from surge protection inside a food factory.
what is the main function of capacitors in mccs.
why swinburnes test cannot be performed on series machines?explain
operation of diesel generator
If any HVDC line is going with positive & negative(the negative usually have return path of current with earthing electrode). Now the question is if this HVDC earthed electrode which is using as return path and earthed any nearby 400kv or 220kv AC substation equipments. which will be the impact of this on AC substation & its equipment, how severe may be this and what should be the minimum distance require between HVDC earthed electrode and AC substation equipments? It's really an high engineering level question...Dare to answer and increase your knowledge.
In constant power region of 3-phase IM torque-speed characteristics, if frequency increases slip A does not alter B decreases C increases D none of above
how does it help for selection of a transformer.
In cable sizing calculation (determining the max route length of cable) why we choose the shortest length between cable length of full load current Iflc & starting current Istart?
what is the criteria for selecting fuse rating in 1phase, 2phase & 3phase welding sets?
Where can I get CPWD electrical specifications & Shedule of rates? Please help me
Can anybody please refer the best and simple book for about Protection relays and in detail of all its protection ?
