Interested to Buy Any Domain ? << Click Here >> for more details...
a 650 KVA diesel generator is 1500 rpm, voltage is 415V n full load amps is 805 something,when are applied load more than 400 amps it's voltage is dropping, what is the reasons...?
- 4 Answers
- 8172 Views
- I also Faced
- E-Mail Answers
Answer Posted / satya dev
There is a lot of reasons to droping thevoltage during the
load.
Electrical reason - 1. Excitation voltage is not build up
to the requiered limit.
2.Fuel pump actuator is not working properly.its required a
certain DC voltage for certain load.
Mechanical Reason- If the DG set is more than two cylinders
may be one piston is not working properly, may be push rod
of the piston got broken.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
State the methods of improving power factor?
What is difference between unity power factor wattmeter and upper power factor wattmeter? In short circuit test of transformer the wattmeter used is unity power factor type or upper power factor type wattmeter?
How wire size can define in electrical wiring? What is the ratio?
1)How much current can a 3-1/2 core 100 mm wire carry? 2)What are the special cables required for explosion proof wiring? 3)In case you do not have coal and salt for earthing, how can you achieve good temporary earthing? 4)One horse power single phase motor is more likely to get hot than a one horse power 3 phase motor. Is it true or false, if true why? 5)What are the different types of soft starters for large motors?please explain?
What is the type of feedback used in an op- amp schmitt trigger?
what are the different methods for the starting of a synchronous motor.
can anyone show me how the 3 phase power is supplied to socket outlets?
what is gridrotor resistance starter
why star point of HT motor not earthed?
Anybody tell me about modbus hex address of l&t trivector meter er300p??I want to read voltage,current,kwh etc via rs485...If anybody have a manual then send on my mail..Brijeshmodi18@gmail.Com
Would you recommend to replace all oil filled cables with xlpe cable for hv transmission with the current technolgy for xlpe cable?
what is meant by class 1 E in electrical power supply?
What are the advantages & disadvantages of a group electrive drive?
I have made a 3 phase thyristor full bridge rectifier. But at the moment it is working only for the half bridge operation. Both the half bridges are on operation separately but when i put it into full bridge operation the oscilloscope output is zero. I rechecked that the pulses are correct for each thyristor. what could be the possible reason for this?
how pt is using
