What is the difference between IS:1554 (Part 1)/1988 &
IS:694/1990 ? What do these two standards specify about?
- 2 Answers
- 18510 Views
- I also Faced
- E-Mail Answers
Answer Posted / manish gupta
Cables covered by IS 1554 have inner as well as an outer
sheath and steel armouring while covered by IS 694 have only
one sheath and no armouring.
| Is This Answer Correct ? | 20 Yes | 2 No |
Post New Answer View All Answers
While testing LA mast,What are the parameter limits ?
what are the standard IR values should be of R-E, Y-E, B-E, R-Y, Y-B, B-R of VCB in closed condition and in open condition for 500KVA & 1000KVA transformers. and what is the acceptable range when tested by 5000V megger.
Where servomechanism is used?
What is genrally the % Impedance of a Dg set? How can we calculate Earthing conductor size for a DG set?
What is mathematical model of a control system?
In CTs tan delta point should be earthed , what is the reason behind it?
what will happen if OLR CT in all phases are short circuted
why the earth is taken minimum in supplying? wather it the proportional factor to getting work any equipment or a power plant?
WHAT KIND OF LIGHTENING PROTECTION SCHEMS CAN BE ADOPTED FOR THE FLAT ROOF OF BIG DIMENSION.
-What shall be short circuit current of LV switchgear for a 1000 kva, 11.415kv, 3 phase tranformer with 5% reactance.
how to calculate cable size in diffrent loads?
l&t switch FN 63 handle position can we change
diameter of cable and core is doubled then the value of capacitance is
Electronic circuit
can anybody send me syllabus of rrb section engg (electrical). and also send previous question pepar...
