Interested to Buy Any Domain ? << Click Here >> for more details...
what is mean ovality?, how it is measured?
- 12 Answers
- 61155 Views
- Greaves, I also Faced
- E-Mail Answers
Answer Posted / iftehar hussain
With reference to the engine manf. tolerances and record sheet, using a calibrated micrometer. Bottom end bearing is removed from crankpin / piston removed. Surface wiped clean. Then at the specified points in the record sheet, measure the diameter. Normally at least 0, 45, 90, 135 deg. with ref to TDC and 5 equal distance locations across the pin.
| Is This Answer Correct ? | 2 Yes | 8 No |
Post New Answer View All Answers
Explain the uses of windmill?
What are you going to inspect or check when you open the crankcase?
how buoyancy force is realte with convection?
what is diameter of a suction pipe?
How the speedo meter ratio was decided for vehicle?
What is galvanic corrosion?
What is the formula for heat loss in a pipe?
what is the use of choper motor in pyrometer ?
What is ferrite?
why the frequency of natural vibration is always greater than the forcedd vibration.??
wt is MAG weld? wr it is specifically used and reason for it .
Define case hardening?
What is the purpose of stern tube?
What is the difference between conversion and enrichment ?
What does following alloy designation indicate fg 250 ?
