Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / arvind panchal
Earthing:means to "to make the potential of the
system/device/network to the earth potential ie to zero
potential".
Neutral: Neutral is a returning path of phase,or Neutral is
a point or node where three phase are connected though
balance load condition it zero potential free point.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
How to configure the drives in PLC, through Profibus commnication. And to how to address it?
what is distribution board?
What is difference between slip rings and carbon burushes?
what is meant by vector group of a transformer? How can it be derived?
how many parameters can integrate with fire alarm basically ?
Dear All we are having a problem in G120 BOP showing alarm A0503, F0052, F0060 we can not remove fault alarm ,Please any body help us. kowsar
I have a CT meter with ratio 60/5. The meter reading of previous month was 3290.49 and that of current month was 3797.26. How many chargeable units as per normal meter should be my reading.
How can we calculate the efficiency of a Running (On-Load) Motor ? What parameters are required and what is the method ?
Cables Construction hi friends, 0.6/1/1.2 kV LV , DC and Control cables are concentric copper conductor what does its means and what is the use of concentric copper conductor,and are this with copper tape shield or copper screening, ? thanks
what is counter poise conductors
what is the difference between ups & inverter
Explain what are inter-poles and why they are required in a dc machine.
Installation resistance for whole installation of 16 kva & 25 KVA DTRA a) Between each conductor b) between conductor to earth c) installation resistance for each apparatus, each conductor to earth d) earth resistance for the system of earthing
When we use air circuit breaker, it has O/L protection ,time delay SC protection, Instataneous SC protection & ground fault protection. They all have some setting range. But what is the suitable/allowable setting for the above protection which will be safe for the equipment? For example-O/L protection setting have a range of (0.4,0.45,0.5,0.55,0.6,0.65,0.7,0.8,0.9,1.0)xIn Time delay SC protection have a range of (1.25,1.5,2,3,4,6,8,10,12)xIn Time delay setting is 0.02,0.1,0.2,0.3,0.4 Instataneous setting is fixed to 20xIn Gound fault setting is given 100A,300A,600A,900A,1200A This setting are for 2500A ACB. So what will be the basic allowable setting for the above protection? is there any formulae to calculate this<
in dc series motor if field wdg is shorted then
