Interested to Buy Any Domain ? << Click Here >> for more details...
What happen if we have run 415 V,50Hz designed motor at on
480V,60HZ
- 8 Answers
- 21327 Views
- I also Faced
- E-Mail Answers
Answer Posted / michael
the motor gets hotter and sooner damage may occur.. it is possible because
of voltage frequency ratio
415/50 = 8.3 480/60 = 8.0
| Is This Answer Correct ? | 0 Yes | 2 No |
Post New Answer View All Answers
Is there any problem about which the drive (inverter) doesn't show/display the alarm and/or fault but instead of this , it doesn't work ? I want to know that could there be any kind of problem in the drive when the drive doesn't display the alarm and/or fault ?
Any one can explaination about calibration with rotating sub standards?
Please tell me the earthing procedures adopted for the STAR-STAR 3 Phase transformer in india and give a better sugession for earthing
ACB & VCB how do work and saftes and how can maintenance in this and parts name show with picture
how to calculate compresor capacity?
Why choke coil is connected in series with starter in tubelight??why starter is connected in parallel to tubelight??
How to Calculate The Neutral Earth flat design calculation for the Synchronised generator (Gen 1-650Kva, Gen 2-725Kva
the typical output of a solar cell is........
What is the difference between shortcircuit current, rated current of cable & MCB with example? What will be the size of cable required for 5.5 KW motor (Full load current 10 Amps approx.), Starting current with DOL is 120 Amps. Aprrox. Short circuit current with LLLG fault is 2000 Amps Approx.
PLZ SEND ME SOME UNIQUE PROJECT OF ELECTRICAL ENG (B.TECH)
do anyone out there know where to find a compleete list on acronyms/abbreviations used in offshore electric engineering. MCB - Micro Circuit Breaker, MCCB-Mouldes Case Circuit Breaker, ELCB-Earth Lekage Circuit Breaker, ELMCB- etc.....
What Is HO factor in power selection
hi, in the event earth grounding is not available in a project, is there any other way to make the elcb work? fyi, i have an instant water heater (6.5kw) installed, however if there is grounding in the heating element inside the heater assembly, i will get grounded. thank you in advance to those who will answer my question.
how to determine the inrush current of a transformer
If I want to buy a new Xformer for my plant what are the main parameter will I need to check?
