For these 2 devices what their power ratings are ?
1) single phase : AC 220V & starting amps 3Amps (i.e.
starting torque) and the stabilized amps 2A ... For deep
freezer
2) single phase : AC 220V & starting amps 2.7Amps (i.e.
including the starting torque of a CRT monitor) and the
stabilized amps 1 Amps
thanks
Answer Posted / k.prakashchandra
Ignore the starting current as it is momentary
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
How to check the cable fault / hv test of transformer cable.
i have install 750 kva distribution transformer at my site and want to do neutral earthing. what calculations should i follow to determine earthing conductor material and size?
what are the reasons of CT circuit faulty in busbar protection scheme?
HOW DO I CALCULATE THE SETTINGS FOR THE DIFFERENTIAL PROTECTION OF A 12kV/6.6kV, 6MVA,DYN11 XMER WITH PRIMARY SIDE CTR 400/1 AND SEC SIDE CTR 600/1?
What is Surge Capacitor? Why it is require in Generator Circuit Breaker,inspite of surge arrester?
why we use condenser in the thermal power plant, althrough the same vapour will be again heated
What happen to generator if i have unbalanced load?
What are the properties of a resistor?
i will applied in 1U-1W on 440 volt primary delta side. what is the result of magtic balance test
Why reactors use before incoming of ac vvfd drive?
Why hydropower is called renewable source of energy?
Why insulation level follows this order? transformer < bus bar < circuit breaker & Isolator < transmission line.
What is the principal of motor?
where can i get vijaya electricals limited in hyderabad interview auestions can u give me the website address plz
what type of questions are asked and howmwny questions belong this catagory?