Interested to Buy Any Domain ? << Click Here >> for more details...
WHAT IS THE DIFFERNCE BETWEEN AIS AND GIS IN SWITCH GEAR?
- 5 Answers
- 24691 Views
- L&T, I also Faced
- E-Mail Answers
Answer Posted / janardhan reddy
IDENTIFICATION OF ERRORS IN GIS IS IS DIFFICULT AND IT WILL TAKE MORE TIME WHEN COMPARED TO AIS
| Is This Answer Correct ? | 8 Yes | 0 No |
Post New Answer View All Answers
various transmission tower like .,D tower ,K.C.O tower ,C.C.O tower,K.C.R tower ,C.C.R tower ,H.C.O tower in different tons.
HOW TO WORK A VFD?SAY SIMPLE METHOD
temp of cast resin 1500kva tx formerwent up to 138.c but came down very fast to about 100.c within 20 mins when load was reduced from 70% to 60%
What are the advantages and disadvantages of negative feed back?
how to revers the direction of single phase motor
How i can decide that HVDC line is best for transmission.
Can Anyone Answer anyone of these ? Q1) why direct SOLUTION of Load Flow Studies in Not Possile ? Q2)Why majority of Buses in power system are load buses Q3)Why one of the buses in Power system is taken as reference bus (slack or swing) Bus ? Q4)Bus Admittance Matrix is a sparce (means it contains some zero elements ) matrix , give reason
how is find out kwh step by step
what is the operating time for LBB and how does the LBB relay realise whether cb is opened or not?
What is shutdown of electrical sub station?
how we arrange the hv side with delta connection in case 33/11kv of transformer.
how the phase convertor changes the no. of phases
what are the disadvantages in GIS over AIS
What is the gross weight to copper ratio in slip ring induction motor of 4000 HP,6.6 kv, 372amp, 992 rpm GE motor.
