How to calculate cement qty of M10, m20, m25 ?
I got the formula but I lost it.
Answer Posted / jayaraaj.arumugam
Dear Friend,
in M10 grade ratio 1:4:8 using 40mm aggregate
*40mm agg - 1.52; 20mm agg - 1.57 volume of ingredient*
since 1+4+8 = 13
aggre - 8/13 * 1.52 = 0.935
sand - 4/13 * 1.52 =0.467
cement - 1/13 *1.52 =0.1169*1440=168.36/50 = 3.37 bags
Is This Answer Correct ? | 31 Yes | 22 No |
Post New Answer View All Answers
What are new methods /technologies of pothole patching?
Which IS Code/American Code applied for coupler test of steel
Actually i am confused that how to calculate the bending moment for a semi-circular beam and curved slab.If any one have a good idea about the matter,please give the answer with a suitable example. Thank you......
significance of specific surface area of particles?
What is the basic difference between OPC
What are the different approaches in designing the floors of the service reservoirs?
What are the govt approvals required for starting of power project. means from initial site grading and excavation work.exm. blasting in hard rock, deep excavation, cut off trees from site.
what is the tensile strength of 10swg and 8swg gabion wire?
What is thumb rule for deep trench excavation
With reference to construction of state highways, please let me know the total Bill Of Quantities as per the following details:- 1) Subgrade - 500 mm 2) Granular Sub-Base (GSB) - 200 mm 3) Wet Mix Macadam I (WMM I) - 150 mm 4) Wet Mix Macadam II (WMM II) - 100 mm 5) Dense Bituminous Macadam (DBM) - 60 mm 6) Bituminous Crust (BC) - 40 mm Road Length is 44 Kms. Road Width is 7 mtrs. Please provide the BOQ of each layer as per Compacted Factor & Loose Factor both. Also, if possible please provide me the approximate details of total material required (all categories viz. soil, gravel, stone aggregrate, sand, bitumen etc.) as per general mix design prevailing in India. Thanks & Regards -- Rokr
how many re use can use shutting material. timber ? ply? steel? plastic? fibre? aluminium? Doka?
what is the Purpose of Adding 20% of wet mortar & 1/3rd to Dry Mortar for PCC & Plastering & Rcc .is there any standard method for adding this .?
what is right & short method of measurement of slab&beam
What is the compressive strength of fly ash bricks?
Can inverted beams used in pipes during construction?