Why 30°phase shift occur in star-delta transformer between
primary and secondary?
Answer Posted / k.prakashchandra
There has to be a shift ,just overlap vector diagrams and see
Is This Answer Correct ? | 2 Yes | 5 No |
Post New Answer View All Answers
why zero sequence impedance measurement is not applicable for single phase GT
HOW TO CALCULATE THE HEAT AND LOAD OF LT-SUBSTATION WHICH CONTAINS 2*1MVA TRANSFORMERS,LT-SWITCH BOARD,MLDB,ACB,BUSBAR,ETC,......?
What is the purpose of using busbar mounting fuse?
What is Anemometer used to measure?
How much dc volt applied in cathodic protection system?
Advantage of LT panel vs HT panel
How to calculate Voltage regulation of 22 KV Over head Line.
hey guys i scored 910 on GRE and 67 on TOEFL respectively.I have an aggregate of about 74%in my B tech.For which colleges should i apply for an MS program in electrical engineering.I am looking for colleges in NJ,SC,NC,GEORGIA, NY. Please reply with a good response.....
distribution is maximum done by a)radial b)network c) parallel d)b & c
can anybody send the rrb chennai &rrb bopal question papers of 2006&2007.My exam is on 12 oct 2008.Its urgent
why co incidence factor considered in transformer sizing?
what is the purpose that we use PLC system in power system
Phase control and integral control are used for?
What is a diode?
what is the major difference between LIBBP & HIBBP.. which one is most preferable..