Interested to Buy Any Domain ? << Click Here >> for more details...
how step down and step up voltage is occured in transformer
- 3 Answers
- 4843 Views
- I also Faced
- E-Mail Answers
Answer Posted / murali290
any machine basic working priciple is FARADAYS LAWS of
electro magnetic induction:
1st law:when ever a conductor cuts a magnetic flux an EMF is
induced dyanamically in the conductor.
2nd law:induced emf proportional to flux linkages(N,rate of
change of flux).
based on 1stlaw emf induced in transformer.
stepdown:as secondary turns are low flux linkages is less
hence induced emf is low in secondary camored to primery.
stepup:as secondry turns are high flux linkages is large
hence induced emf is high in secondary camored to primery.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
what is the practical application of full adder circuit?
In ht capacitor ckt we are using LBS Panel it having isolator with fuse, one of HT fuse flash over, so what is reason behind this event.
May I know how much values to be set for earth fault, over current and short circuit values at 11kv side? I have 11kv van 1250amps rating. Present it's taking load 80amps?
1. Design a counter which counts 0, 4, 8, 2, 6, and repeats using: 1.a using JK flip flops 1.b using T flip flops 1.c using D flip flops
what is the safety of voltage power transformer(2250KVA0
What is meant by load angle of an alternator? Upon what factors does the load angle depend?
I have a drawing of a wound rotor induction motor for a crane. This crane motor has 5 forward speeds & 5 reverse speed implemented of course with different amount of resistance for each speed setting selected. What has got me scratching around is the fact that 8 of the 10 speed selections switch in uneven (unbalanced) amounts of resistances on each of the 3 connections to the motor's rotor.Can this be possible? I would have assumed this would produce unbalanced rotor currents and therefore vibration in the motor. I would greatly appreciate anyone's comments on this. Many thanks, Confused.
What are the commonly used schemes for the bus zone protection?
what is per unit calculation?looking for simple and strong explanation thk u
Discribe type of fault in DOL and stardelta startor.
Could you measure voltage in series?
how we arrange the hv side with delta connection in case 33/11kv of transformer.
how does the rotating m.m.f is produced in the 3-phase induction motor and how the poles are created in 3-phase induction motor ?
please send me RRB electrical engineer previous year questions for Sr. Section Engineer
could you measure current in parallel?
