Interested to Buy Any Domain ? << Click Here >> for more details...
how can we check a fully charged battery?
- 6 Answers
- 10430 Views
- BEML, Singareni Collieries, I also Faced
- E-Mail Answers
Answer Posted / rahul
its so simple because the voltage is always mentioned in the
battery we can check it using a multimeter or voltmeter or
using a hydrometer we can check the specific gravity of the
battery a fully charged battery have a gravity of 12.75 and
weak have 12.50 and below
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
WHY BREAKER ARE USED IN SUBSTATIONS?
hi , i have 150 kw loud and we need 50 m cabil,i want to know wich size cabil we use. thanks
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
Is it required to lay GI wires along with GI/MS conduits from one point to another point though separate earthing cable is conncted from DB to Socket?
How much weight an electrical engine can pull??
what are the stresses in circuit breakers ?
What is transmittance?
What is systematic error?
In Dyn11 power transformer if any one of the 3 phases connected to earth in star connected side then please explain effect of the current flow in delta connected side of transformer.(In this case if one phase is shorted to ground in star connected side then we observe the current flow in two phases only not three phases in delta connected primary side. Please explain why it is so?)
What is the effect of solar radiation on the design of an Isolated Phase Busduct?
what is the excess air in furnace
I HAVE A INCOMING 100A MCCB TPN 25KA, CABLE LENGHT OF 80M 70MM CABLE SIZE FROM MAIN SUBBOARD TO NEW DB.BASE ON THE FAULT LEVEL SETTING OF 45KA.I WOULD LIKE TO FIND OUT 25KA ENOUGH KA. APPRECIATE IF SOMEBODY CAN ASSIST ME WITH FORMULA FOR THIS. FRM: JEFF
hi friends how 3 phase converter functioning ?what is working principle of rotory phase converter ?
how the B-H loop obtain under the static condition
what is the reason the main breaker is trip during the motor is running? (some time the breaker is not trip)
