Answer Posted / shyam kishor
Merz-Price protection is the method used for protection of alternators. it is a most common system used for the protection of stator winding faults employs circulating current principle. in this scheme of protection,current at the two ends of the protected section are compared. under normal operating conditions,these currents are equal but may become unequal on the occurrence of a fault in the protection section. the difference of the currents under fault condition is arranged to pass through the operating coil of the relay. the relay then closes its contacts to isolate protected section from the system.(Ref. book on power system v.k mehta and rohit mehta)
| Is This Answer Correct ? | 65 Yes | 8 No |
Post New Answer View All Answers
What is the voltage gain or transfer function of amplifier?
what is the basic construction diffrance between servo motor ans sqiralcage induction motor
What Maximam Gap Taibaar & Bush
What are the advantages of hydropower?
How you calculate the repturing capacity of a HRC fuse
What is force on parallel conductors ?
what is high and low cut off voltage of BB and DG at SPS????????
Which thing is maximum in RLC circuit at resonance a)power consumption b)inductive current c)capacitive voltage
some basic standard questions on transformer.
what do you mean by type zero control sytem ?Give an practical example of type zero contol sytem?
can we use trip light with bus coupler?
List the characteristics of filter?
what is meaning of 230volts ac 50hzs ac supply is it rms or maximum to getting ac 230v what amount of max voltage they will send
1)How much current can a 3-1/2 core 100 mm wire carry? 2)What are the special cables required for explosion proof wiring? 3)In case you do not have coal and salt for earthing, how can you achieve good temporary earthing? 4)One horse power single phase motor is more likely to get hot than a one horse power 3 phase motor. Is it true or false, if true why? 5)What are the different types of soft starters for large motors?please explain?
63MVA,220KV/6.9KV Transformer LV side neutral is connected to Earth pit through NGR. Whether this earth pit required to connect with near by below grouding earth mat or it is to be kept separate?