what is diff between auto level and dumpy level?
- 4 Answers
- 66529 Views
- ABB, L&T, NCCL, I also Faced
- E-Mail Answers
Answer Posted / sagar sontakke
Above answer is partially right.Major difference between these two is, in auto level readings are actual as staff seen from the eye piece is straight where as in case of dumpy level staff is inverted so that we have to adjust the readings accordingly.
| Is This Answer Correct ? | 104 Yes | 21 No |
Post New Answer View All Answers
how many material required for brickbat water proofing of toilets.
In Residential home construct footing,beam, column,lintel,rcc roofs which dia rod used how to self assumed
Explain what is Critical Path Method (C.P.M)?
A sieve analysis results in 100% retained in no. 50 Sieve, the fm is?
How to measure the requirement of cement n sand for 12mm and 20mm plastering thanks in advance
what is the calculation of raw material for 0.35cum of m-15
what is the difference between np2 and np3 concrete mix
What is the life of anaerobic Digester if it is used for municipal solid waste digetion.
How much material is required for constructing a 2 Lane 2Km rigid pavement road
What are the common ways of demolition?
reinforcement slab, beam and column formulas?
With reference to construction of state highways, please let me know the total Bill Of Quantities as per the following details:- 1) Subgrade - 500 mm 2) Granular Sub-Base (GSB) - 200 mm 3) Wet Mix Macadam I (WMM I) - 150 mm 4) Wet Mix Macadam II (WMM II) - 100 mm 5) Dense Bituminous Macadam (DBM) - 60 mm 6) Bituminous Crust (BC) - 40 mm Road Length is 44 Kms. Road Width is 7 mtrs. Please provide the BOQ of each layer as per Compacted Factor & Loose Factor both. Also, if possible please provide me the approximate details of total material required (all categories viz. soil, gravel, stone aggregrate, sand, bitumen etc.) as per general mix design prevailing in India. Thanks & Regards -- Rokr
What are the advantages of cad software?
beam length 73 feet 4 inch,width 01 feet,height 50 inch so every beam load how much? and what quantity of M.S ROD? both side ony two column in middle no column.pls inform me that this is stable or not ? and how much risk of this beam?
Time required for curing of wall tiles before fixing
