Interested to Buy Any Domain ? << Click Here >> for more details...
Suppose am having the PF value .8, so how can we say that
is it lagging or leading?
- 11 Answers
- 15924 Views
- Bhel, I also Faced
- E-Mail Answers
Answer Posted / santoshvarma
Just is the KVAR value from multifunction meter if it is
positive then 0.8 is lagging pf and if the KVAR value is
negative then 0.8 is Leading power factor.
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
how much maximum load a 2 core (Single phase) 16mm aluminium wire can take ?
ii) A shunt motor supplied at 230V, runs at 900 rpm when the current is 30A. The resistance of the armature is 0.4 ohms. Calculate the resistance required in series with the armature to reduce the speed to 600 rpm, assuming that the armature current is then 20A. [12]
A 3 phase transformer's (Y-Y) Y and B phase is (Y and B connection not broken) broken from neutral and R and Nutral connection is ok, what will be the relay tripping and why
why output is out of phase in case of common emitter?
what is earthing.how we make it,describe briefly.
how can we change the phase angle b/w two phase?
how to measure earth resistance of a substation
Why neutral cable carry current.
is IS says that neutral should be brought to switch box. and this one is a recomended practice
What consists of 2 or more thermocouples to be connented series?
I just purchased a 4 position cam switch to be used to operate a 3-speed blower motor. The motor is a 10 amp motor and has 3 wires that are used to control speed. The cam switch was rated at 660V 20 amps but when I received it, I noticed that it has AC-15 operational current rating (Ie) of 4/5 amps. If I am reading the label correctly. the 4/5 amps is related to 440v/220V (Ue). Other ratings are AC-3: 5.5A, AC2: 7.5A and AC-4: 1.5A. My questions are 1) Is it safe to use this switch with the motor I have 2) what is the difference between the 20 amp Ith ratting and the Ie operational ratings?
How the setting of the vector surge relay shall be calculated when the relay is to be used for Grid islanding application?
why you don not show protection and type of isolation in key single line diagram?
Bimetal strip used in overload relay what is that,which types of material used for that & percentage.
What is the difference in calculating size of AC cables compared to calculating size of DC Cables? Usually DC Cables are larger than AC Cables although they have the same ampacity. Why is it?
