Interested to Buy Any Domain ? << Click Here >> for more details...
Is it necessary to place tap changer in secondary winding or
we can use on both sides?
- 3 Answers
- 6076 Views
- I also Faced
- E-Mail Answers
Answer Posted / atti
Tap changer placed normaly on HT side .Because there is high
voltage and low current .Due to low current value we install
T_Chsnger on HT side .There are many advantages
1-No spark on T/F.
2-No Harmonics Are Produce.
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
what is transient stability analysis means?
how the inner and outer body is separated in aircrafts?
difrent between vcb acb sf6 and mccb breakers
What is the source of dependent source ?
The sodium vapor lamp is not glows when it is connected a distance of 5 meters above from gearbox, why ?
What is the difference between Static and servo controlled voltage stablizer?
My question is whether bellow formula is correct to find bus size for 46kA for 0.5 second & what is RT in bellow formula. formula to calculate the size of busbar to withstand the thermal stresses due to currents with duration of 0.2 sec to 5 sec. Sp = RT( I x I x t) / K Where Sp – is the cross sectional area of bus bar in millimeters. I - is the value of AC fault current. t - is the operating time of disconnecting device in seconds. K – is the factor depending on the material of the conductor, insulation and initial and final temperature. Value of ‘k’ for copper is 143.
How a band pass filter is constructed?
lenz law application and define
What is the effect on Power factor and capacitor when your company load is more than 70 % of welding transformer
What is the importance of counter based plan & how is it scheduled?
what is value of Jin transformer
sir,in our plant we r using SATEC PM172E power reading meeters in HT panel side it is monitoring the MB data smart viewer(sever).but last one week we did not get readings inthe server only available in meeter.tell me how communicate meter and server. and also what steps we take for checking.
what is difference between earthingpits,earthing grid & earthing mess?
If UG power cable both ends are to be earthed or what? If not why?
