why does chattering take place in ac contactors?
can it be avoided & what care does the manufacturer take to
eliminate this phenomenon????
- 10 Answers
- 53035 Views
- I also Faced
- E-Mail Answers
Answer Posted / bhanu dudhat
i agree with above answer and
also manufcture can add
sheded pole ring when it
design bcoz ac current flow
positive ok but naturle side
pick up not possible so and
thats reasen they add sedded
pole ring for continios hold
contactor.
| Is This Answer Correct ? | 1 Yes | 20 No |
Post New Answer View All Answers
is there any lightning by passer is arranged in ship like buildings?
y we use neutral,all r told its used to for closed path..k its a just used to closed path,in a transmission line y we put same conductor used n both phase and neutral..if we use less than phase conductor in neutral mean we ll reduce cost its right r wrong..if we use mean any problem occur in transmission line..
1.what is the difference between transformer differential and busbar differential.2)why we are using 2 slope for trafo diif and 1 slope for busbar diff.3)what is the purpose of metrosil and stabilizing resistor in high impedance relay circuit.4)how metrosil reduce the peak volage.5)what is the funtion of stabilizing resistor
What are diffrent type of road taxes?
for what voltage will reactive power be largest in 380 kv line : a) 375kv b)380kv c)385kv
Why HT 11 KV Slipring Motors are connected in star ?
What is the difference between shortcircuit current, rated current of cable & MCB with example? What will be the size of cable required for 5.5 KW motor (Full load current 10 Amps approx.), Starting current with DOL is 120 Amps. Aprrox. Short circuit current with LLLG fault is 2000 Amps Approx.
Transmission voltage is kept 11KV,33KV,66KV,132KV,220KV due to form factor. What happen to 400KV and 765KV transmission voltage?
how we can decide that what value of ht line will come to any commercial building? (ans except According to the building load)
What are unstable systems?
How does a transformer contribute towards the widespread popularity of ac system over dc?
we all know voltage is a force(emf), and the force always devides if 2 or more than2 loads are there but why does the voltage remains same is parallel, it must devide na ???
Write the force balance equation of m ideal mass element.
what is the differance between HT motors And LT MOTORS.
why can the rotor of 3 phase slip ring induction motor not be a 2 phase rotor?
