hello every one,
what is the difference between the Kvar and farads, Rating
on Power capacitor is for eg: x kvar, and normal capacitor
is eg: x farads.
what is the relation between these two?
- 3 Answers
- 5997 Views
- I also Faced
- E-Mail Answers
Answer Posted / muthuvel
kvar-kilo volt ampere with reactive component
farads-unit for capacitor
a set of x farad capacitor can develop y kvar capacitor bank
for power factor correction.
kvar-unit of reactive power developed by capacitor bank for
power factor correction
kva2=kw2+kvar2
| Is This Answer Correct ? | 3 Yes | 2 No |
Post New Answer View All Answers
what are the range of memory address in plc for L&T lx7 4A
plz send me Bhel, Mahagenco, sbi previous exam paper for electrical engineer on my email-id kambali_smita@yahoo.co.in
what is the minimum (Common factor) insulatin resistance of the following a, 4mm sq wire b, cable from 50 mm sq to 800mm sq
why high speed tripping relay will be used in tripping circuit why not normal relay
what clearance required for 4.5 mva dry type transformer?
What is signal flow graph?
how we can do the insulation on secondary of ct explain and so that tan delta will within limit
what is frequency response?
Name the component u would expect to find in a switchgear assembly?
what is the difference between rectifier and converter and commudator?
y we use neutral,all r told its used to for closed path..k its a just used to closed path,in a transmission line y we put same conductor used n both phase and neutral..if we use less than phase conductor in neutral mean we ll reduce cost its right r wrong..if we use mean any problem occur in transmission line..
why only exciting current is shown not primary current in transformer???
how are reversing the direction of dc motor
A TRANSFORMER 440/400V,DELTA/STAR CONNECTED.THE NEUTRAL CONNECTED WITH GROUND CABLE THAT IS DIRECTLY CONNECTED TO THE PANEL,FROM PANEL IT IS CONNECTED EARTH PIT.IS IT RIGHT? IF IT IS RIGHT LEAKAGE CURRENT AFFECTED.SECONDATY IS PROTECTED WITH EARTH LEAKAGE RELAY.
how we decide the require size is this for a known current at fuu load?
