Interested to Buy Any Domain ? << Click Here >> for more details...
10. THE MOST COMMON TYPE OF THREE PHASE IN UNSYMMETRICAL
FAULTS IS ........
- 6 Answers
- 14201 Views
- SSC, I also Faced
- E-Mail Answers
Answer Posted / banti rawat
Double line to ground fault is common fault in unsymmetrical fault
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
What is an order of a system.
how the phase convertor changes the no. of phases
Calculate torque developed by the 3-phase, 5 H.P., 4 pole induction motor runs at 1500 rpm A 23 N-m B 21 N-m C 10 N-m D 0 N-m
How to measure size of cable on a given load
What is a diode?
Explain what is electric traction?
Why we use 4-20 mA Analog signal for the PLC input? Why not 0-20 mA? Why not 5-25 mA?
A Question Like A Wire Is Wound Whose Resistance Is Some 132. 44647 Ohms. If A Voltage Of 30 mv, 296 Ma Current Is Applied To It What Is The Resistance.
How many types of interlocking use in screw type air compressor,make-Kaser(BSD MODEL)?
how we calculate the short circuit capacity of the busbar in LV & HT?
how to determine Sq.mm size of finolex power cables.
What is Negative Potential Bias
A car's starter motor draws a current of 100 A at 12,0 V when starting the engine. The mechanical power required to turn the engine is 960 W. At what rate is energy from the battery converted to non-mechanical forms of energy?
sir, i am 3 years diploma course pass out candidate.what type of certificate can i got in marine service.
what is the use of commutator in dc motor if we supply ac ? commutator is used to convert ac to dc.and it is used to arrange the flux in unidirectional in case of dc supply. if we give ac as supply to dc motor what is the use of commutator?
