What is the difference between Type test and Routine test?
- 10 Answers
- 129397 Views
- I also Faced
- E-Mail Answers
Answer Posted / manoj sharma
Type tests are done at samples for confirming design
parameter while routine tests are done at each and ever
items before dispatching material to sites.
| Is This Answer Correct ? | 10 Yes | 5 No |
Post New Answer View All Answers
1- What is the Polarization Index number be good for 15KV 3c#500MCM electrical cable? 2- Can I use the IEEE Std 43-2000 to perfom the PI test? Thanks
How to do bus bar short circuit calculation for 230KV/11kv, 60 MVA Substation?
what is a reactive power? what is the relation with power factor?
mccb service sittings be done?
how to calculate the surge level of surge suppressors related to the SF6 cicuit breakers?
wat is d diffr btw shunt coil and trip coil in VCB?
How to identify the start and end of 3phase 12 lead motor if U1, U2, etc numberings are lost or erased.
if voltage bt phase & nutral is 38v in a panel board . whats the root cause.
why power factor is important?
our factory is going under construction mean time transformer 1000 kva 2 nos &load break swithch 12 kv & 4 nos 750 kva 2 nos & 380 kva 2 nos generator to be errcted.how to arrange earth pits &how to earth connect & neutral pit how to calculate in earth bit size.
what is parellel power factor correction?
how to select the double earth conductor if 21A full load?
when the time of backcharging the transformer three phases only enough or three phase with neutral is must.from these which one is the best one.
what size steel armoured cable is required to support 1500kva capacity. would 70mm squared be enough or would I need 90 or 120mm squared 3c plus earth
What is the relation between frequency and motor rpm?
