Why a starter is used for a motor?
Answer Posted / selva ganesh
IF YOU GIVE SUDDENLY MAXIMUM (FULL) CURRENT APPLIED ON
MOTOR MEANS THE MOTOR COIL SYSTEM WAS TOTALLY DAMAGED.SO
WILL USE THE STARTOR MEANS TO GIVE THE CURRENT IS
UNIFORMELY (CURRECTLY).
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
all the technical question with answers pleas send your email id ramar_eee@yahoo.com
I meggared my 2c*70 sq mm AL AR XLPE cable. its one end show 50 M ohm . is my cable is safe for laying. I have only one phase and neutral.
what is the use of permanent magnet generator in exciter
What is the effect of interchanging core(made of steel) and winding(made of copper) material in case of transformer? Give proper explanation in regard to different losses in transformer.
What is the tests required for a 132 kV, 400 kV , 765 kV for a Circuit Breaker and Power Transformer before commissioning ?
What are the reasons for the parallel operation of transformers?
A 100KVA SINGLE PHASE TRANSFORMER 10000/200V,50HZ REQUIRES 300V AT HV SIDE TO CIRCULATE FULL LOAD CURRENT WITH LV SHORT CIRCUITED.THE INTAKE IS 1000W.THE % OF REGULATION ON FULL LOAD AT 0.8 PF LAGGING WILL BE HOW MUCH AND THE SECONDARY TERMINAL VOLTAGE ON 0.8 PF LEADING WILL BE
what will be d.g. capacity to cater together for 14hp A.C. load & 3kw lighting load
Write the analogous electrical elements in force voltage analogy for the elements of mechanical translational system.
Explain Need of a starter in a dc motor.? Also explain any two starting and speed control method of dc motor?
The series field winding has low resistance while the shunt field winding has high resistance. Why?
A TRANSFORMER 440/400V,DELTA/STAR CONNECTED.THE NEUTRAL CONNECTED WITH GROUND CABLE THAT IS DIRECTLY CONNECTED TO THE PANEL,FROM PANEL IT IS CONNECTED EARTH PIT.IS IT RIGHT? IF IT IS RIGHT LEAKAGE CURRENT AFFECTED.SECONDATY IS PROTECTED WITH EARTH LEAKAGE RELAY.
what is the affect of earth's magnetic field on the frequency used in aircraft???
how to find number of run cable laying[LT side] for transformer & alternator secondary side? [above condition for getting output power transformer to main panel side] give the example.
when we gave dc supply to 220v dc motor its rpm is 1200. then we gave 180v. how many rpm of its motor. gave answer with calculation at my ID.... ravizak@ymail.com