Interested to Buy Any Domain ? << Click Here >> for more details...
I have flow transmiter DP range is 0 to
5000mmwc,(convert) Display to be show in
m3/Hr.
- 3 Answers
- 16950 Views
- Orient, I also Faced
- E-Mail Answers
Answer Posted / sivaram
Dear bro.In flow calculation Need Design DP and Q Parameters,Then configure range DP ,out put function Sq root display range configure Given Q,Simple you will get Exact
flow
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
what are the documents(Construction point of view for a process plant) submitted by contactor initially entering in to new site for client?
1.what is controller proportional gain 2.what is the controller intergral action time. 3.A proportional plus derivative controller that has a proportional band of 20% and a derivative action time of 0.1 minutes. Construct the shape of the output waveform for the triangular input if the input rises and falls at the rate of 4 units per minute.
What is force balance principle?
god evening sir i am studying m.sc(tech)electronics &instrumention.am i elegible to all industies
I have 0.75mm sq multicore cable (IS type) , can use instead of same type but 1.5 sq mm cable ? Note : The distance is around about 150 meter.
How can we test a bently nevda 3500/42M accelerometer monitor card by simulating it with test equipment?. what king od of signal (milli volts or volts or or resistance ) we should feed in the terminals of the card?
WHY THE DEGREE OF VALVE PLUG AND VALVE SEAT IS SLIGTLY DIFFERENT I CONTROL VALVE TRIM DESIGN
it is possible to check the fail safe condition in pressure transmitter. if possible how?
How to calibrate Toxic gas detector?
how will you check torque value during Factory acceptance Test for control valve/ESD ON/OFF VALE how will you confirm this torque value is being correct, Which document will you be refer.
who's take first position in process in the timing of new installation flow transmitter and control vavle. give the answer with logical trick.
what diffrence b/w plc s7200,300,400
Q-Explain the different load conditions that will produced different offset which may or may not be acceptable to thhe control function
What is the use of double seated valve?
Im having problems with interfase betwen SPI v7.0 and SPPID v5.05. Previous versions of Intools shoul be fixed with SPPIDproj.ocx file. It was necessary to replace this file with one that allows the connection between different versions of SPPID. It is necessary in the current version to do the same?Thanks
