could i arrange a faulty and healthey battery bank togather
in parallel , if your ans is not then why?
Answer Posted / abhishek goyal
No because faulty battery bank both rod or plates are melt
we also called it might be short. so if we connect the
faulty battery bank into parallel connection with healthy
battery it will be discharge through the faulty battery.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
how to find out 3 phase complex power in per unit in unbalanced system?
Determine the BTU size of an aircon for 20 sq metre room
What are the characteristics of negative feedback?
Dear all, I want to use Induction motor to open and close a 1 ton door. How much power do I need. Thanks
What is precision of a measurement?
what is conductor copnstant of ab cable
the site measured knee point voltage of protection class CTs should be greater than rated knee point voltage? what about meetering class CTs. Should it be below the rated knee point voltage?
I am about to write exam in RRB bangalore for the post of section engineer.please provide me with previous exam questions
Is there a possibility to use such a treshold voltage for the NMOS part of a CMOS circuit that during the switching it will start conducting only after the PMOS part will be already closed, by this eliminating the leakedge current? Please note, I'm not asking about the well bias in standby mode, but about the "antileakedge" measures during normal operation.
What is the Basic Difference bitween Long Shunt Connection and Short Shunt Connection in DC Generator?
what precautions to be taken while desigining a LT,HT panel. Eg-LT panel PCC panel with ACB installed. HT panel VCB panel with VCB installed. & what is main diffrence betwn IP54 & IP55 construction of panel.
What is the use of mc( moving coil) in dc voltmeter and dc ammter and what is the use of ( moving iron)in ac voltmeter nd ac ammeter
How to Calculate Current Rating of SDFU (Switch Disconnector Fuse unit) for Protectionof Capacitor Bank connected to Busbar of 800Amp,in LV side of 11/0.433KV, 250KVA Transformer?
a governer in an Ic engine controls the
What are the advantages of a three-phase system over a single-phase system?