Answer Posted / rama kranthi sri
it is because the neutral wire carries only the unbalanced
current. it doesnt carry the full load current. so, the
neutral wire is thinner when compared to phase wires in
three phase.
Is This Answer Correct ? | 3 Yes | 1 No |
Post New Answer View All Answers
what is th basic difference between a d latch time line and a d flip flop time line???
wat is the first thing dat is needed, 2 lay a cable in some area??
What is the difference between the transmission line and distribution line?
Define peak time.
while doing high voltage test on 11kv/433 distribution transformer why we only give 28 kv on hv side and 3kv on lv side for power transformers what is the value what factors it depends
power transmission pole used one support , that only for support or earthing
can we install HT panel & LT panel side by side or how much clearance is required ?
What is the most essential condition for the voltage build up for a d.c. Shunt generator?
DESCRIBE THE CONSTRUCTION ANDOPERATION OF BELT CONVEYORS AND SCR CONVEYORS , DRAW NEAT SKETCHES
hi Is there any possibilities to find out the rotation of a shaft or something else by using electromagnectic waves or by IR rays.If s then can v change the dir., of rotation of the same by remotely?& how? plz dn't any1 say "NO r CAN'T"
Define end float in a motor?
What is the formula to calculate the no load current of a single & three phase induction motor
No load tap changing transformer working
What it the purpose of parallel phasing transfomers??
how oti and wti connections are different from each other?