arcing is due to only capacitance or it is due to both
inductance and capacitance? explanation.
- 2 Answers
- 3437 Views
- I also Faced
- E-Mail Answers
Answer Posted / kaushik
arcing is due to both the passive element
when ever there is element which stored energy as electrical
voltage and we roughly try to connect the two terminal of
charged passive element like short circuit the terminal we
will have arc. as with neglible resistance the current is
very large and with lack of proper connection between two
terminal current tries escape through air from one terminal
to another causing arcing.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Define damping ratio.
if 2 coil of 1000W connect in series and 200 v is applied across it . then what is the total power of coil when coil have only resistive load .
a starter used for squirrel cage induction motor?
How to run a three phase motor into single phase........
im working in one private compeny in gujarat. i was complet diploma electric in 2010 from gujarat technical board. now i want electric supervisor licence in gujarat but i dont't know when i apply? plz give me address of the licence dippartment office in gujarat. gandhinagar
Compare jfet’s and mosfet’s.
sir please tel me how calucalte kwh if home taken load 30ams how maney kwh taken per day.and 3phase motor 5hp per hars how maney load teken and how mach kwh and forward me to electrical table for calicalte kwh and kvr and kvah
From past few months I am getting lagging pf even though sufficient capacitors used in circuit. Where is the problem pls answer
how to find ratio of CT & PT in 66/11kv 12 mva supply system ? explain with calculation.
1.what is the difference between transformer differential and busbar differential.2)why we are using 2 slope for trafo diif and 1 slope for busbar diff.3)what is the purpose of metrosil and stabilizing resistor in high impedance relay circuit.4)how metrosil reduce the peak volage.5)what is the funtion of stabilizing resistor
calculate external resistance values to add to the rotor of a slip ring induction motor. STATOR- 415 V, 3 phase delta, 1100 A, 50 Hz, 1490 rpm, pf 0,86 ROTOR - 660 V, 590 A, 50 Hz. STATOR current at each steps STEP1-600A,STEP2- 800A,STEP3-1000A,STEP4-1100A.
If we want to change a contactor of faulty one what are the conditions want to fullfil
Explain forward resistance, static resistance and dynamic resistance of a pn junction diode.
How we can calculate the life of Lead acid battery
Why are cables rated for 40 KA for 0.25 Sec fault current rating?
