Why Pressure Transmitter is NOT installed before up-stream of an ORIFICE PLATE? in a flow measurement.
- 4 Answers
- 7475 Views
- Mecon, I also Faced
- E-Mail Answers
Answer Posted / ashwani kumar
I had never came across this situation.
Orifice creates a pressure drop across the plate and hence measuring the pressure on the upstream doesn't provide any significance. Pressure after the orifice always carries significance.
| Is This Answer Correct ? | 9 Yes | 0 No |
Post New Answer View All Answers
sir,would you please send me the Hindustan petroleum corporation limited papers(HPCL).my e-mail ID is ujjwal_sharma1983@yahoo.com
how to measure draft pressure in transmitter pl. give its single line digram
Can I calibrate the Electromagnetic Flow Meter on line and How.
How ejector(or)evactor air pump is working in thermal power plant?
i have been asked by QAFCO to appear for interview for thy post of Instrument Designer(INTOOLS)..i m engineering graduate with 5 years exp. in design engineering.Will this job profile suit me??i need all ur help n suggestions for thy same?
What happen if we install my pressure transmitter below the elevation of pipe in natural gas service?
How servomotor controls throttle valve of TURBINE?
Why upper weighing limit of electronics balance is 90% of the total weighing capacity?
can anyone can let me know in Eurotron Micro cal 2+ calibrator in milli amps source mode we are not able to get 20 milli amps output it only produces 1.52 milli amps out, but display shows increase in milli amps , and err6 displays, let me know how to remove the err 6.
what is isloted barrier how it works and what are the main purpose.how it make safe area.
How is automatic reference junction compensation carried out in temperature recorders?
I want to measure and control level in tank of size 10*5 filled with gasoline, so plz give me the solution with clear details. how to select transmitter and sensors.
HOW TO CALCULATE ACCURACY OF AN INSTRUMENT. WHICH IS COMPITABLE FOR USE.
Pressure tx shows 1 mbar but we need 1000 mbar at this process condition .. how can we sort it out .
How to Calibrate Ultrasonic Level Transmitter in field
