Why Pressure Transmitter is NOT installed before up-stream of an ORIFICE PLATE? in a flow measurement.
Answer Posted / uttiya hazra
Pressure transmitter is not installed before up-stream of an orifice plate because in the region of up-stream there exists a pressure differential or pressure gradient.
Is This Answer Correct ? | 2 Yes | 2 No |
Post New Answer View All Answers
hi my name is rakesh patel i just complited my be in instrumentation & control now i am going to working as a validation engineer in a poject department so what is a scope in a future as a validation engginer ? what line is good for me can any bady give me complete solution please? your regard rakesh patel
What is the procedure of calibration of Load cell?
OBJECTIVE TYPE QUESTIONS OF ANALYTICAL INSTRUMENTATION
what is insdustrial vibration.who it works. give atleast 2 types of insdustrial vibration
find the kp ki kd from the transper function G(S)=29.44s+04707/1.5349s2+s
How to find out the current of two motors having same power consumption but different RPM?
Yokogawa CENTUMVP R6.09 unable to download to Engineering Station with ExaOPC R3.75
The issue is when I try to download the common project section to the Engineering Station (STN) from the HIS in System View, it is unable to connect. The error displayed is:
WARNING: Could not connect to equalize destination. (7001)
Retrying. Number of retries = 0/1
ERROR: LdXopsLoadMain: connect error 10060
ERROR: Processing terminated due to connection error. (7002)
Equalization end with errors. STN0149
---- ERROR = 2 WARNING = 1 ----
Background:
>Updated the ExaOPC software on the STN from 3.60 to 3.75
>STN operating system is Windows Server 2008 R2
>HIS operating system is Windows Server 2016 Stanard
Solutions attempted include:
>Ensuring all IP addresses are correct and all networked devices can be pinged.
>The ability to ping a device using its host name from another device (
can you provide me full detail about instrumentation in ONGC??
If i have 4 Allen Bradely make RS logix 5000 PLC and for viewing that we are using 4 RS view SCADA for 4 different packages. Now, I will want to view two packages on only one SCADA. Then how i will do it?
explain key exchanges in all security modes WPA,WPA2,TLS?
what different types of problems do occur while doing instrumentation commisioning and how to solve them? please explain in detail
we want to control pump in let pressure and tank (for exp) our inlet line if water cam and pump will on and when our tank will full pump will off also if our inlet pressure low pump will off even tank not full.this pump i want to uses on our water supply line.
how to measure draft pressure in transmitter pl. give its single line digram
how to tune siemens sipart electro pneumatic positioner..plz tel me..
how will you segregate the alarm levels in alarm management system during factory Acceptance Test