Interested to Buy Any Domain ? << Click Here >> for more details...
what is the potential difference between line and earth?
- 11 Answers
- 17801 Views
- I also Faced
- E-Mail Answers
Answer Posted / chandimitra
It is line voltage only.If you connect line( Live wire) and
the earth with a suitable wire the fuge will melt.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
What happens if we give the supply to the rotor of induction motor and make its terminal shorted?
what is the difference between rectifier and converter and commudator?
what's the difference between 'shaft power demand' and 'BHP' , when we consider electrical load list.
what is the voltage regulation for unity and zero power factor?
1. What is differential relay? How it operates? 2.How to calculate the Short Circuit Impedance in Transformer? 3.What is the alternate solution for testing of polarity by using polarity tester while its milli ammeter does not works? 4. While testing the 33KV Busbar by using Hipot kit, what should be the test voltage we have to apply? 5. What is the procedure/activities to be taken to inject the current more than 2000A by using 2000A Loading Transformer? 6. Explain how you can give the overload setting to any Motor Protection Relay for a HT motors with formula and example? 7. Why restricted earth fault protection is needed? Why can’t differential Protection is sufficient? 8. What should be the minimum and maximum ohmic value for earthing? 9. Why DC Currents are not used in transformer? 10. What is the Frequency while we step up the voltage from 220V to 11KV? Is it possible? Explain it?
What happens if i apply 500V to 440V rotary Switch ?
Whether the vacuum contactor requires Short circuit protection?If No,why?
i am an maintenance engineer. one distribution board have 5 feeder. recently its ELR trips frequently, but it take some times after trip( 10min,20min..)but 3 feeder no load. two feeder only loaded. i checked one feeder IR value all values are above 50Mohm.but B phase to Earth is only 9Mohm.any problem about low value
stand by earth fault protection (51G) for transformer rating 2000 kVA,Dyn11,33/0.400 V. LV NCT ratio and necessary resistor and metrosil values how to calculate
i have applied for junior engineer 2 c&w for Guwahati RRB please send me last five year question paper
For electrical designers what are the standard should know? i want learn about this standards. how to get information/reference. anybody help in this regards please.
what are the standard IR values should be of R-E, Y-E, B-E, R-Y, Y-B, B-R of VCB in closed condition and in open condition for 500KVA & 1000KVA transformers. and what is the acceptable range when tested by 5000V megger.
what do w do when the output of generator is fluctuating?
How to calculate Number of Earthing Pits....???
Please send 110 kv sb station full single line drawing(sld)
