Interested to Buy Any Domain ? << Click Here >> for more details...
how to check the earth resistance value& what is the
minimum earth resistance for good earthing sysytem.
- 33 Answers
- 153313 Views
- Brookfield, BSNL, DMRC, Epoch, KPTCL, Polycab, Power Control, SIEA, Siemens, Wipro, I also Faced
- E-Mail Answers
Answer Posted / robeesh
Earth Resistance test to be conducted on summer conditions to achieve the correct value by using an earth resistance tester (From Megger/ Sanwa/ Fluke). The value should be less than 1 Ohm for electrical earth pits and less than 10 Ohm for Lightning protection System. Procedure for testing should be as per the equipment.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Mention what are the types of semi-conductors?
Can we put 3 layers of cable tray while installing tray
How do i perform grounding of star point of Genset (400V) for making connection with step up transformer of DELTA-DELTA (400V to 20KV) ? while Genset itself has its own neutral and grounding bus bar inside genset breaker box whereas we have another neutral and grounding busbar in synchronizing panel next to genset at maximum distance of 6meter, would someone pls advice if we can only perform neutral grounding in synchronizing panel or should we ground neutral on both places inside genset breaker box and synchronizing panel.
what is the calculation method to design core and winding of a 200kva 3phase distribution transformer?
what is through fault?
what are the differant std sizes of cable trenches?
What is meant by celling voltage & current in excitor ?
why current flow to the opposite direction of flow of electrons???????????
if the number of poles generated in stator and rotor side of an induction motor are different then what will happen and why?
what happend to DC shunt motor if its field winding insulation becomes slightly weak? will that motor can run on full load or not explain in detail. thanks
How can you calculate the size of the down conductor cable for the lightning protection system. Is 70mm2 cable can replace 95mm 2 bare copper cable when the copper tape size is 25Wx3 thk mm.
What is CCM in Electrical ? where can we use this material?
What is primary and backup protection?
What is difference between start imitation and start interlock for 3 phase motor protection ?
how much LT load can bear by the 100 KW HT connection.
