Answer Posted / shahbaz shaikh
because at the start current is very high due to less
resistance of the rotor and there is no any contact between
stator and rotor and it genrat very high torque hence
require very high current.
| Is This Answer Correct ? | 6 Yes | 9 No |
Post New Answer View All Answers
Why do we use copper cable for HT Supply and why not Aluminium?
What is knee point voltage?
What is the procedure/activities to be taken to inject the current more than 2000A by using 2000A Loading Transformer?
What is the most essential condition for the voltage build up for a d.c. Shunt generator?
What happens when ac supply is given as excitation voltage instead of dc supply
Convert a star connected network into a delta connected network.
What are steps to be taken while designing of DYN11 distribution transformer to achieve magnetising balance?
magnetizer priciple
What types of CMOS memories have you designed? What were their size? Speed? Configuration Process technology?
During Starter Panel Com missing I Found The Main Incomer 40Amp MCB 10KA Trip When Motor Change Star To Delta Motor Rating 20HP BUT When We Use Same MCB To Other Motor It Does Not trip Or What Is Necessaries for Star Delta Starter MCB SFU MPCB OR MCCB And What are The Breaking Capacity of MCCB in the Motor above 15HP
we have require a Motor (1500kW, 6.6kV, 50Hz) which shall operate at 1500rpm during 30min and after it shall run on 500rpm during 15min. The same cycle shall be repetitive during the whole working days. Which method is best and economic to achieve such type of task. VFD, VVFD, Pole changing motor etc.
why should small green grass ans small plant should not be there inside the transformer Yard in the factories
What is the difference between acs 550 & acs 850
what is the transmission loss for electrical supply? specifically a large shopping complex where the grid is half KM away, what will the % of transmission loss? is there any transmission loss for captive unit generation for above set? thanks
what is zinc diffusion?