Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / bimal sarkar
Copper loss in transformer due to current and iron loss due
to system voltage. There are no phase angle between voltage
and current so not depends on load power factor. So total
loss of transformer depends on volt-ampere (VA).
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
Which type of DG need Netral Earthing?
i will applied in 1U-1W on 440 volt primary delta side. what is the result of magtic balance test
what is the voltage between earth & neutral in 3 phase electrical connection.
Motor,transformers,capacitor tubelight etc....
best manufacturer for busbar for outdoor switchyard having double bus bar scheme, can any one share technical specification of busbar. 132kv voltage ?
How can you calculate the size of the down conductor cable for the lightning protection system. Is 70mm2 cable can replace 95mm 2 bare copper cable when the copper tape size is 25Wx3 thk mm.
How do you select the pickup value of the relay?
Why we use Electrical energy rather than any other type of energy, mostly? Explain behavior of open secondary CT and short circuited secondary PT in energized condition?
How Load Factor, Demand Factor, Diversity Factor etc best applied in designing an electrical circuit? Is it allowed to consider these factors in each and every panel in an electrical distribution system? Can any body suggest a good book for reference?
Is it possible to measure the voltage of a battery from a single terminal?
what is calculation mathod/formaulla for deciding Size of busbar (Copper/ aluminum)for L.T. panel on Various Fault level like 50kA,25kA,10kA
in a simple IDMT relay we use neutral point of ct for earth fault then what is the requirement of neutral ct and cbct?
As i want some model question paper in basic computer science and history please send me immediately sir
how pt is using
TRANSFORMERS WITH DC SUPPLY
