what is the rating of power
generation in india?
Answer Posted / yash
6.6 KV
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
battery capacity use of made?
What is the loss of power of transformer 220kv/33kv,63/80mva of % imp12.05 at 80%load
why the perameters of secondary circuit are more important then that of the primary circuit of induction motor?
in a solar power plant,we are going to step up the voltage 350V to 33kv, and to 132kv GSS. i want to ask that if it is possible that 315v/33kv is not possible because we also use 315v/11kv. or it should be 415v/33kv? is it effects generation or losses? the second question is-generation is depends on LV winding? or LV winding design for generation voltage?
hi can anyone pls tell me the eee interview core questions asked in l&t
how does a submersible pump work..?
In single phase capacitor motor, if the motor rotate reverse direction then how much power will be consumed by the motor and why?
What conditions are required for transformer to operate at low frequencies ?
How harmonic block test are conducted on relays ( Siemens,Areva ect )power transformer using omicron kit?
explain with diagram how to protect transformers and substations from over current with help of CT's?
what is relation between ct and pt ratio with multiplication factor of a energy meter? is there any other factor on which multification factor depend?
What is line resistance of cable & how it can be measured ?
How to calculate the sag of OPGW during stringing???
What is the need of earthing transformer for delta side of a transformer. (Think of a line section between a star/delta transformer at a grid substation and delta/star transformer at a village. An earthing transformer is there at the delta side of the star/delta transformer at grid substation). As there are no ground reference there will not be fault current if a one phase is grounded. Further L-L phase will be sensed by the primary side of star/delta transformer as a L-G fault. So why an earthing transformer is required at delta side
Is it possible to operate a synchronous 2-poles turbogenerator with a still-in-place faulted bar but electrically disconnected ???? If yes, should I act on the other phases as well ???