Interested to Buy Any Domain ? << Click Here >> for more details...
If Solenoidal valve works in manual mode but not in Auto
mode. What should be the problem?
- 8 Answers
- 11924 Views
- Bharathi Cement, Titanium, I also Faced
- E-Mail Answers
Answer Posted / satishkumar
first, check the SOV coil is working or not and then check
the power supply from DCS to sov coil.
| Is This Answer Correct ? | 18 Yes | 5 No |
Post New Answer View All Answers
what is the procedure of O2 sensor(ABB) calibration?
How to Calibrate Level Troll in field
Where Can i take a SPI INtools training in Mumbai? In Rolta India Ltd to whom I should approach regarding of SPI INtools Training?
Can anybody please let me know Orifice plate sizing calculation formula and step by step procedure
what is isloted barrier how it works and what are the main purpose.how it make safe area.
How d.p. Transmitter can be applied to open tank?
Difference between ultra sonic flow meter
selection of the zener barrier for the hazardeous area zone 0
What is the use of GMV in turbine?
Can I route 110 VDC and 24 VDC in a same Duct for our Interposing relay cabinet? IF yes or NO Please provide me IEEE Std. for the same. Please i required it on Urgent basis, i need to design IRP Cabinets and we have MCC 110VDC and Our Coil side is 24VDC, Please help as soon as possible.
Draw a simple circuit for a well head control panel used to protect the well against fire, leak, blockage, ESD, & controls the operation of one downhole & one surface safety valve. Explain the operation and controls
principle of dead weight tester ?
why Fahrenheit unit of moistur analyzer transmitter
I was working on calibrating turbidity transmitters endress+hauser at effluent polishing plant.We calibrated using NTU buffers.What happened is that when we immersed the sensor, everytime we raise and lower the sensor gradually, the reading will vary.my question is that is there any specifications on what is the required distance from the bottom of the container with buffer to the face of the sensor?Is it ok to install the sensor in a medium which has turbulence specially if bubbles are present?
Hi,can anyone help me out with PhD programs related to Instrumentation field?I have a degree in electronic Instrumentation?
