how to checking earth restence with earthtester
Answer Posted / malliyadhav3
mulitimeter
| Is This Answer Correct ? | 0 Yes | 4 No |
Post New Answer View All Answers
What happen if 200 KVAR capacitor connected to power continuesly?
what is difference between speed mode and torque mode in motor?? explain in simple words please.
We have drive feeding an output contactor for a 5000 hp motor @ 5kV application. The motor FLA is 629amps x 1.25% service factor = 786.25 amps The cable that we current have in place between the drive and the output contactor is 350kcmil- MV-105 (parallel cables). Per the NEC table 310.60 (C) (69). This show the cable ampacity is at 615 amps per cable for a rating of 1230 amps. We have derated the cable for the cable tray and the multiple cables application and our calculations show that after the correction factor factor we are at 922amps. 1230 amps x .75% correction factor factor = 922.5 amps. The customer is driving us to then use another safety factor of .25% off of the already derated cable. Can you please provide a longhand calculation for your solution on this application?
(1)WHAT HAPPENS WHEN SUDDENLY LOAD GIVEN TO THE INDUCTION MOTOR ? (2)CAN WE MAKE WOOD AS MAGNET ? (3)WHAT IS THE VALUE OF MAGNETIC FLUX DENSITY IN TRANSFORMER ? (4)WHY WE ARE USING ELECTROMAGNETI NOT ELECTROSTATIC IN MACHINE ?
How much costly in percentage wise is sandwich busduct costly than air insulated busduct of any rating?
what is value of Jin transformer
how to generator maintenance (A Check, B check,Etc)
BSNL TTA EXAM QUESTION
What are the effects of electrical faults?
3phase motor can be used as a Prime mover for alternator.
my UPS suddenly goes off and all panel light also blow off.This happens even main electric supply is not interrupted.After some time it automatically starts functioning normally.Batteries are new.
please tell me when we start motor without load in star or delta connection whose current above condition,pl write formula
State the frequency for rc phase shift oscillator?
What is the meaning of utility ground and clean ground? How the distribution panel is grounded?
Use of switch mode power converter in real-time basis?