Interested to Buy Any Domain ? << Click Here >> for more details...
Q- voltage source of 12v is driving the circuit.if circut
draw the current of 0.5A them source voltage will became
11.8v.what is the power dilevered by source when circuit
draw 5A current ?
- 4 Answers
- 6790 Views
- Ecil, I also Faced
- E-Mail Answers
Answer Posted / satya
59 watts
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
how will you check torque value during Factory acceptance Test for control valve/ESD ON/OFF VALE how will you confirm this torque value is being correct, Which document will you be refer.
What is stripper & spilitter ? Diffrence in this.?
what are the steps I have to deal with?
we are having yokogawa centum cs3000 dcs in our power plant. i need some of the operator guides NOT to appear in HIS0163 AND HIS 0162 but it shoul appear in HIS0164 HOW TO DO IT?
Speedtronic system .
Why does a pressure gauge installed on reactor, doesn't have any vent line below to release the pressure? Is it any kind of designing mistake or it actually does not require any vent line? And if it does not require any vent line below it then how we are gonna release the pressure built inside the pressure gauge?
TECHNICAL/ARTITUDE
what is scale factor of proximitor & unit of the vibration.
How does work A temperature valve or fv control valve in process plz brief me
What is the difference between ff transmitter and non ff transmitter
In Safe Guarding test what means by "Failed to Danger" ?
How to regulate the flow of Air in 4" line, with max flow of 330 nm3/hr and Pressure of 0.5 bar? please suggest the type of instrument required.
key phaser where is use and work
How many types of sensor
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
