Interested to Buy Any Domain ? << Click Here >> for more details...
How can calculate ups battery back up time?
- 25 Answers
- 168664 Views
- Cisco, Cooper, Pronet, Wipro, I also Faced
- E-Mail Answers
Answer Posted / akshay kumar
UPS BACKUP TIME=CONNECTED LOAD/(BATTERY VOLTAGE*NO. OF
BATTERY)
SUPPOSE CONNECTED LOAD = 1KVA,BATTERY VOLTAGE=12,NO OF
BATTERY=2 THEN
BACKUP TIME =1000(1KVA)/12*2
=1000/24=41.67 AH
(IT MEANS BATTERY DISCHARGE CURRENT =41.67 AH IN ONE HR.)
IF YOUR BATTERY CAPACITY IS 150 AH THEN
BACKUP TIME=150/41.67
=3.35 HRS (APPROX)
| Is This Answer Correct ? | 4 Yes | 5 No |
Post New Answer View All Answers
What is the Resposiblity of Electrical Utility Engineer
How to know the following data of synchronous generator 1. D-Axis Unsaturated Reactance 2. D-Axis Unsaturated Transient Reactance 3. D-Axis Unsaturated Sub - Transient Reactance
Why in power plant projects we see DOL starting method used for motors upto 160 kW instead of star delta method
what is the reactive power what is the use of it in system
What is the formuala to calculate the rating of motor protection circuit breaker
what is the step by step formula for calculating bus bar phase and neutral size of a panel board.suppose the incomer of panel board is 100A..???step by step answer please
How to know Resistance and Reactance value of main and aux winding of single phase capacitor start capacitor run induction motor to find capacitor value?
Difference between low impedance and high impedance Restricted Earth Fault
what is the responsibility of C license holder in industry?
What is a single phase autotransformer?
What is grid collapse? what is the reason for it?
Is there a possibility to use such a treshold voltage for the NMOS part of a CMOS circuit that during the switching it will start conducting only after the PMOS part will be already closed, by this eliminating the leakedge current? Please note, I'm not asking about the well bias in standby mode, but about the "antileakedge" measures during normal operation.
i m in need of current rating chart of heavy duty pvc/xlpe, cu/al cables. can somebody provide me? if yes, plz send me at ashish_patel111@yahoo.com
How we calculate the Multiplying Factor of Kwh meter for 3 phase alternator.
In a large office how do we calculate required number of light fittings, assuming fittings are 4x18W or 2x36W fluorescent fitting ?
