Answer Posted / nagaseshareddy.m
The ratio of the sum of the individual maximum demands of
the various parts of a power distribution system to the
maximum demand of the whole system. Note: The diversity
factor is always greater than unity.
Is This Answer Correct ? | 69 Yes | 19 No |
Post New Answer View All Answers
block diagram of 2 ups system connected in hot stand by mode?
How we calculat the NGR of 3phase Generator, Our generation voltage 11KV
In hydel power plants, L.A's, S.C's are placed inside the control panel boards. what is the purpose? [already the total body was earthed to ground.]
control & auxilary circuits used for circuir breakers
Why hydropower stations are preferred solution for meeting peak loads in grids?
How to Calculate Current Rating of SDFU (Switch Disconnector Fuse unit) for Protectionof Capacitor Bank connected to Busbar of 800Amp,in LV side of 11/0.433KV, 250KVA Transformer?
Is potential difference materials property ..? if yes tnen how.. explain brifly.
explain remenance . differentiate high remenance type ct & low remenance type ct
how to caculate cable size for diff types of loads? if anyone know the calculating procedure please tell me
What are the site acceptance tests for power cables, DG Sets, LT panels & 30kVA UPS ?
why do we use 25kv supply for traction purpose?
HOW TO CALCULATE THE HEAT AND LOAD OF LT-SUBSTATION WHICH CONTAINS 2*1MVA TRANSFORMERS,LT-SWITCH BOARD,MLDB,ACB,BUSBAR,ETC,......?
How to test Alternator stability test for REF relay
what is a vector protection in transformer
What is the alternate solution for testing of polarity by using polarity tester while its milli ammeter does not works?