Interested to Buy Any Domain ? << Click Here >> for more details...
How to Calculate the maximum Demand required for a
connected load for a manufacturing Plant
- 6 Answers
- 82116 Views
- I also Faced
- E-Mail Answers
Answer Posted / sachin
First try to know what is mean by max demand . Max demamd
is the simutaneous max requirment of power for any unit.
there is no standard practise to calculate the MD of any
unit . but one can carry out as follows.
1] CALCULATE THE TOTAL CONNECTED LOAD .
2] APPLY DIVERSITY FACTOR - IT IS THE PART OF EXPERIENCE
AND MAY VARY FROM UNIT TO UNIT .
3] TOTAL CONNECTED LOAD X DIVERSITY FACTOR = MAX DEMAND
| Is This Answer Correct ? | 27 Yes | 9 No |
Post New Answer View All Answers
What will be the diameter of pipe between conservation tank and transformer
Which cable is use for rtcc control panel
which metal is use in shunt
Which contains in POLE ASSEMBLY of a 11KV Kirloskar-make SF6 (Model No-FP620A12)? Will u clarify with drawing?
What is the meaning of C1, C61, C91 cable
Benifits of 3ph 4 wire metering over 3ph 3 wire
how oil in the MOCB was reduced compared with OCB? what are the features of the MOCB?
Why the efficiency of generator is more than motor in swinburne's test
Why does the speed regulating system adopting I controller have no steady-state error? In this single closed-loop speed regulating system, when the input of the I controller Un=0, what is the output voltage of the regulator? What factors do the output voltage depend on?
State uses of different types of stsrters with different capacities of motors as below: a. up to 5HP b. above 5hp to 10hp c. above 10hp to 20hp d. above 20hp
how to compare with Relay settings for HT< panels, RMU panel, and PSS CSS transformer?? 1) Load amps, 2)Tripping time, 3) CT ratio, 4)Cable size 5) Transformer KVA rating 6) transformer full load amps
what is the necessity of under ground cables ??
what is the formula to calculate voltage drop/loss on 66KV Transmission Line?
Where servomechanism is used?
Why hydropower stations are preferred solution for meeting peak loads in grids?
