Wat is power factor exact meaning in terms of technical
terms plz explain ?
Answer Posted / balu
power factor is the ratio between active power and apparent
power. apparent power = active power + reactive power.
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
why we are using Load factor?
what precautions to be taken while desigining a LT,HT panel. Eg-LT panel PCC panel with ACB installed. HT panel VCB panel with VCB installed. & what is main diffrence betwn IP54 & IP55 construction of panel.
stand by earth fault protection (51G) for transformer rating 2000 kVA,Dyn11,33/0.400 V. LV NCT ratio and necessary resistor and metrosil values how to calculate
UG cable sizes were specified in sqmm. But practically its not coming to mesure. What's the reason for that? And how they specify the size of the cable?
CT Ratio of a energy meter connection is Red Phase : 100/5A, yello Phase : 50/5A & Blue phase : 100/5 A what is the overall Multiplication factor
what is breathing?
pre arcing time of ehv breaker
Did RMU have ct and pt ?
What are the causes of having an rmu explode after installation? And how do u treat the bushings of an rmu?
what is the difference between 50 hz freq. and 60 hz freq.? which is better and economic in them ?
What do you mean by the zone of protection?
what is the vvvf in the dumbwaiter?? or lift. what is the actual process?/
What OPGW is better than Microwave or PLCC???
Dear sir, my knowledge about cable size determination is limited. Though I read examples I could not calculate the Cable size required for electric driven pump 40 KW, 380 Volt, 50 HZ, 50 meter from transformer and it is three phase star delta starting. Please help as there is no one in my surroundings to help.
if grounding is notdone at regular intervals for long distance transmission, will the load connected at distribution end receive voltage during negativehalf cycle of the sine wave?