What is the difference between online ups and offline ups?
- 44 Answers
- 207051 Views
- Electrical Tech, GMR, Gravity India, HCL, Indus Towers, NIT, Pyramid, Techno Electric and Engineering, UBS, I also Faced
- E-Mail Answers
Answer Posted / vinay srivastav
On line UPS gives out put through inverter card out put at
all time AC supply on or off. That means UPS always on and
gives AC out put which is converted from DC out put of
Battery voltage. But the Battery life in this type of UPS is
low as compare to that of offline UPS.
But offline UPS gives out put only when commercial supply is
off. commercial supply directly given to the load and when
commercial supply fails UPS feeds the supply to load. That
means UPS is not connected to load at all the time. In this
case battery is not connected all the time so the battery
life is more as compare to online UPS
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
stand by earth fault protection (51G) for transformer rating 2000 kVA,Dyn11,33/0.400 V. LV NCT ratio and necessary resistor and metrosil values how to calculate
can a 150 kva 3 phase 440v/230V delta-wye step down transformer can be use as step up transfoermer with connected loads at 440v side?
what is buffer resistance starter.?.What is the working principle and where it is used..?
hai...... tis is Hemanth. jst now completed electrical engineering... i wanna to apper for ap tranco exam... plzz send me the previous q's paper link......thanx in advance.
How to arrange a hous hold earthing system to keep minimum earth resistance( below 7ohms).
What will be the effect of circulating current in HT xlpe cable when both the armour ends are grounded. Will the termination fils after some time in case of 33 kv supply.
How earthing/grounding done in aeroplanes and ships.
Where should the lighting arrestor be placed in distribution lines?
What will be the size of copper cable (each for 3 phase and 1 neutral) from Service connection Kit-Kat to Panel Board (i.e. to main switch) for a 6 pole 3-phase AC induction motor of 200 H.P. capacity? Amp-255 A, Frequency:- 1450 rpm.
How each of the following losses occur in d.c machines (i) copper (2)core (3) windage (4)friction please help me
Explain the experiment on ward leonard method of a speed control on a dc shunt motor with an suitable circuit diagram.
How Can I calculate for the photometrics requirements for a street lighting? Data given are: 45 units of 6 meter light pole with 150 watts metal halide lamp, 220 volts and installed in a promenade area.
please write motor, transformer, Generator setting, fault level calculation of Tr.etc
what is auto re-closer?
What is the tests required for a 132 kV, 400 kV , 765 kV for a Circuit Breaker and Power Transformer before commissioning ?
