what is the basic principal of vertax flow meter
Answer Posted / www.islamqa.com
Vortex flowmeter is a velocity based flow measurement device.
It consists of a flow tube with "Bluff body"/object with a specific dimensions/shape put in the flow path to generate vortices in the flow stream.
The vortices generation rate is proportional with fluid flowrate, these vortices is hitting a pressure sensor (piezoelectric type), the hitting rate is proportional to the flowrate.
The basic formula for getting fluid velocity:
V=DF/S
D:Bluff body dimension
F:vortices hitting frequency which is measured by pressure sensor.
S:Strouhal No.
Q=A.V, A:Flow path area
Adv. of no moving parts exist so we have high accuracy & stop in case of sudden flow stopping.
Disadv. of low accuracy with low flowrate.
Ahmed Sabry
Instrumentation & Control Engineer
Mob: +2 122 1367310
Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
what is the field bus calble ? what are diffrences in orang colur cable and black coular calble ?
How to convert Differential pressure to flow in TPH
I need control valve ISA hand book. Is there any site to download that big book containing all the pages. Written by Paul Friedmann
What is defferent betwen ESP &PCP PUMP .HOW IT IS WORK?
How to decrease opening & closing time of on/off valve?
What are different types of orifice plates? State their uses.
Why even multiple power supplu r used in instrumentation system?
Where are oxygen analysers installed in cfbc boilers? What are their usual readings?
How can we use feedback signal frm rtd for monitoring and in dcs for controlling ,then which type of rtd is sutaible 2 , 3,4wire and why ?
How signals can be taken through modbus?
what is basic difference between motion balance and force balance in pneumatic instrument?
TECHNICAL/ARTITUDE
What is rang ability?
How you calibrate absolute pressure with the calibration range of 0 to 1000 0C Absolute. Please explain the procedure for calibration.
i have been asked by QAFCO to appear for interview for thy post of Instrument Designer(INTOOLS)..i m engineering graduate with 5 years exp. in design engineering.Will this job profile suit me??i need all ur help n suggestions for thy same?