Interested to Buy Any Domain ? << Click Here >> for more details...
How we can do the linearity test for Bently Naveda
Vibration Probe?
- 1 Answers
- 18357 Views
- Sabic, I also Faced
- E-Mail Answers
Answer Posted / ahmed sabry
first, we have 3 main types of Bently vibration probes:
1 - Proximity probe
2 - Accelerometer probe
3 - Key phasor probe
For proximity probe, we have 2 types:
1 - displacement probe for axial forces measurement.
2 - velocity probe for radial forces measurement.
Both tyes of probes are calibrated using a suitable calibration kit supplied by the vendor, the calibration kit simulate the shaft vibration and can be used to check/adjust the probe and the monitor.
I have a practical experience with 3300 system which give the output through "proxomiter" from terminals output & ground - for normal case it has to give "-10 vdc" and we have 200 mv for every 1 mil diplacement.
This is an example of used calibration kit:
http://www.ge-mcs.com/download/sensors-and-transducers/141580.pdf
==========
If we need to Check/calibrate the rest of the vibration loop (monitor check), We will need a function generator & multimeter.
For the monitor we will inject in the Monitor card by the function generator a combination voltage of -7 dc voltage with AC voltage with suitable freq.(follow the manual to specify the values of AC, DC and freq.).
For axial vibration monitor we will vary the DC amplitude and check the results on the monitor.
For radial vibration monitor we will vary the AC amplitude and check the results on the monitor.
Best of luck
Ahmed Sabry
Instrumentation & Control Engineer
Mob: +2 0122 1367310
| Is This Answer Correct ? | 18 Yes | 1 No |
Post New Answer View All Answers
Describe a time when you anticipated potential problems and developed preventive measures.
how will you check torque value during Factory acceptance Test for control valve/ESD ON/OFF VALE how will you confirm this torque value is being correct, Which document will you be refer.
pls provide me syllabus and old question paper of instrumentation engineering for GET(JSPL)
why any measurement made interms of pressure is more accurate ? to be more precise most of the flow velocity is made interms of pressure and it is accurate. what is the reason behind pressure measurement being accurate ?
can anyone tell me about the basic concepts to consider before to start a PLC panel wiring
Is it ok, to use non-contact type Radar type LT, on a tank that is half circular from the bottom side? If yes the, isn't the waves gonna bent in other directions?
How to Calibrate Level Troll in field
how can leve transmetter calibate in feild .and also put cv and flow plz .....
what is diffrance between FF & SMART, explain with difination
What is the cascade control
whats the abbreviation of IOP? is it instrument of power or input open problem?
How to control flow variations in magnetic flow maters..... When i will provide proper earthing?
PT RTD Range: -200 to 500 degree celsius If I configured in DCS Lower range and Upper range . In face plate it shows red colour due to overa range how was the characteristics look If the temperature is more than operating range. how was the characteristics look . whether its in Resistance vs Temperature curve is Linear or Non linear
what is performance test.need defination
What are continuances of connecting earthing and shield of branch cables (instrument to Junction box), at the same earthing pot provided on JB? Is it ok, or may produce some problem?
