Why sip ring used in ac motor also why its not used in dc motor?
- 2 Answers
- 6086 Views
- RRB, I also Faced
- E-Mail Answers
Answer Posted / r g sabnis
Well, the slip rings are used in AC ( Crane duty Motors )
to add extrenal resistance to increse starting torque.
DC motors are with different construction. A commutator is
used to supply DC to armature.
| Is This Answer Correct ? | 4 Yes | 2 No |
Post New Answer View All Answers
at what rate the micro controller increment its timer....is it 1micro seconds or 1/(12*10^6) seconds
WHY EARTHING NOT NEEDED IN BATTERY IN SUBSTATION
What is the differance between 2 dc motors of armature voltage 660 v and 440 v?
what is the basic need of domestic loads 1- voltage 2- current
I need bhel electrical test pattern & paper
what happens if dc supply is given and the remedies for it.
how to setting Load amps tripping time and extra settings for load Transformer protection relay with RMU panel using C&S model relay..?
What is the Current equation in series RLC circuits.
What do you mean by passive circuit elements and why these are called passive?
what is the function of bearing in dc mchine" and where it is placed
need to make a report. Need to choose a 3phase induction motor. Load conditions motor will operate in : Maximum Load: 30 Kw Speed: 2950 rpm Ambient temp: 20 cent Supply voltage: 440V Frequency: 50Hz need to look for the safety factor when choosing the motor, went through catalouge found a few, but dont know how to choose the safety factor allowing an extra load something above 30 KW to avoid any harm.
Y phase plates are used in transmission line??? what is there need???
what is the function of gss in the dg set.
What is s-domain and its significance?
Explain mechanical rotational system?
