Answer Posted / manan bhatt
it is HIgh POTential test which is generally done on power
transformers to check their capacity in various electrical
terms.
Is This Answer Correct ? | 0 Yes | 6 No |
Post New Answer View All Answers
during installation time of transformer and alternator which points we have to observed?
A powerplant has 8 gensets operating in grid parallel mode. In one genset sometimes there is pf variation and kvar variation. The plant operates in pf mode. When this variation is observed the load is stable, voltage is also stable, freq and genset speed is also stable. How will you check the functioning of pf card. What shall be the ideal output vdc of the pfc, from there it is input to AVR?
explain remenance . differentiate high remenance type ct & low remenance type ct
Explain and give examples about VCB?
why don't we use the generator as a motor? and what will happen?
Single phase and threephase power calculation
What type of DC motor would you see for a lift?
Define peak overshoot.
why ss stablity limit is more transient stablity limit?
How can I model an open-delta ground transformer for a network supplied by 4 unit GTG and power transformer in ETAP?
Why is it prefer to initiate circuit breaker failure by "86" lockout relay not by "94" tripping relay ?!
How earthing of switchgear system to be done.
How much ph is maintained of water resistance starter for slipring induction motor ?
Define steady state error.
how we explain parallel paths armature winding?