Interested to Buy Any Domain ? << Click Here >> for more details...
Why only negative 24 vdc supply give in vibration measuring
system.
- 6 Answers
- 17615 Views
- I also Faced
- E-Mail Answers
Answer Posted / mohammed abbas
Because it is NPN tansistor during the initail days when
this was inveted by bently the cost of NPN transiator was
less. then they started use NPN transiator for the
vibration propbe, due to this we will give negative 24vdc
supply
| Is This Answer Correct ? | 5 Yes | 7 No |
Post New Answer View All Answers
Explain the working of rota meter.
Why rdt and thermocouple both give different output .and one things more, how to generate ohm or mili volt plz mail me merajalam143545@yahoo.com
the pump holds on run indication into the dcs and filed local control panel remote push button condition operaton wrong like when the push button pushing conditions the pump is off and the push button release condition the pump is on totally opposite condition . And control room inside give the stop command into dcs just 1secon relay engage and again normal condition. How can I slove
we have level transmitter for h2s04 storage tank capacity 10k ,always there are failure of transmitter due to failure of magnetic floats ,please come up with solutions at the earliest.
Meaning of the following a. IOP- Manimum; b. IOP- Maximu,;
Explain working principle of lvdt?
Please send me the sample question of Instrumentation of hpcl/iocl exam. my mail id hihi_kiholo@rediffmail.com
What is wet leg condition and why is it used?
How can test or measure the probe and extension cable to identify if the problem at the probe or cable or at the driver it self? (pleast notify the measuring method)
what is thermo coupler and how it works
What is the right procedure for adjusting the gap voltage of bently nevada vibration sensor?
Name different parts of a pressure gauge. Explain the use of hair spring in the pressure gauge.
i have done DAE in Instrumentation and Process Control. i have applied for an apprentice training in chemical company after three day my interview will be conduct but i need more information about industrial process control and controller. my e mail is imran_dilsetu@yahoo.com please tell me interview question relative to instrumentation ?
i have used level transmitter in starch cooking preparation tank. tank total height 2mtr.sometime LT display shows some error value when tank is fully empty and diaphragm side i already checked okay no problem in diaphragm area. field cable checked 24volt and mA shows correct value while tank empty mA is 4mA. 4mA i needed that 0% but display showing 10% or 15% percentage values are varying continously please give any good solution for me.....
steps for installing orifice plate?
