What is the formula for finding fault level of generator?
- 11 Answers
- 35085 Views
- I also Faced
- E-Mail Answers
Answer Posted / ramesh
From your question I guess there is transformer between the
11kV & 6.6kV you are referring to. We need the transformer
MVA and the impedance percentage.
Once your provide the transformer MVA and its %impedance I
can answer further
mail-behera.ramesh@orisysinfotech.com
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
what are the advantages and disadvantages of oil filled cables over XLPE cables
1. If 8.35%Z means the percentage impedance of 132kV-line from power company, we will like to reconfirm its base capacity.
neutral earth resistance testing is it possible for transformer while in load condition
state types of reflectors in illumination engg. ???????
How do we arrive at selecting reactive capacitance value as 30% of h.p rating of motor?
how to do the ductor test?
we have consol make 3 phase servo stabilizer for cnc m/c. while installing the earth neutral voltage is 1.7 volts at stbilizer off condition and when stabilizer get on en voltage reaches 4.8 volts (new earthing is done and neutral is helthy condition all phase to neutral volts 440,442,441 v)why this happen.solution for cause.
Why do we apply both Differential and REF (HV and LV) protection schemes on YNyn configuration of a transformer?
in wind mill use 2100 kw asychronous generator ( induction generator ) rotor voltage : 3300,stator voltage : 690, rpm : 1511 type : MRL063E04 ' we check rotor resistance magger value found following. R-EARTH - 00 M.OHM,Y-EARTH-34 M.OHM,B-EARTH- 33M.OHM R-Y: 31 M.OHM, Y-B: 00 M.OHM,B-R :33 M.OHM HOW CAN I TAKE DECISION?pls ans. quickly
What happened if C.T mount at any cable or Bus bar in wrong direction . C.T going on proper work or not . C,T direction is essential thing to properly work.
how desiel generate sart fail of eb?
diff. between tension mode & speed mode
how point on wave controller works.
where is the need for short circuit test for 3 see is required and why? can you explain in brief with application
Why can't we parallel the secondary circuits of two voltage transformers?
