Interested to Buy Any Domain ? << Click Here >> for more details...
Normally the
starter used to
reduce the
starting
current.but the
dol starter do not
it,so why we use
it?
- 4 Answers
- 9762 Views
- I also Faced
- E-Mail Answers
Answer Posted / naresh
The name itself indicates direct online starters and these
starters will employed for low rating motors, because in
low rating motors the loaded torque is also low and
capacity of starting current will not be such high enough
to make severity, but the protection of motor at voltage
levels is important. DOL starter not only ensures on & off
but the magnetic opearting coil functions in proportion to
the rated voltage. at low voltage the magentic coil trips
down and at high voltages the coil gets damaged. here the
coil used is very sensitive to the voltage and hence it is
voltage protection device and the bi-metallic strip inside
starter makes it current protection device.where as mcb is
only current protection device.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
if voltage bt phase & nutral is 38v in a panel board . whats the root cause.
Types of test in Switchgears, MCC, NGR and DB's how it should be procced. Can anyone give me the details here or email me to pasuvaraj.k@gmail.com
How much no load current of synchronous motor
In all analog voltmeters or ammeter showing some small size symbols. as well as a star and in star 2no. digit, resister symbol,and other. what is that's meaning ?
can the measured percentage error during calibration of single phase energy meter be negative?
Is it true online ups having bypass mode if it is true then why we called ups because it is interrupting power when goes in bypass mode
Why HT 11 KV Slipring Motors are connected in star ?
what will happen if frequency is below 50 hz?
how many joint can done in HT line and what is life of the joint
I have a situation to design sub-Distribution board/Panel meant for feeding power sockets. In the incomer CAN i Take TP MCCB with Neutral Link and All the outgoing feeders with to sockets with TP MCCB and Neutral Link? P.S : My System is IT Earthing
What is the maximum No. of out going mccbs permitted from an LV distribution paqnel? What is the ampere relation between incomer and out going switch gears/mccbs?
What is negative sequence over voltage element?
How isolater function when installed inelectrical 440V wiring
in single phase converter, the no.of scr's conducting during overlap a)1 b)2 c)3 d)4
Could Please Explain briefly. Why used stabilizing resistance series with High impedance bus differential protection relay.
