why there is a phase shift lies between primary and
secondary voltages of a transformer?
Answer Posted / ajith nair
The question is what is the main reason for phase
displacement is it the air gap/flux density or what is that
paramaeter?
so If the phase displacement is 180 degree then how the
phase angle becomes 30 degree when we use Dyn11
transformer.How do we make that?
thanks
Is This Answer Correct ? | 2 Yes | 2 No |
Post New Answer View All Answers
How to connect the chemical earthing and complete process tell me plz
How to see the inductance in a transmission lines
what is kondo syatem in eletrical traction
What is the basic of DTH.
In Dyn11 power transformer if any one of the 3 phases connected to earth in star connected side then please explain effect of the current flow in delta connected side of transformer.(In this case if one phase is shorted to ground in star connected side then we observe the current flow in two phases only not three phases in delta connected primary side. Please explain why it is so?)
71ohm,111ohm,95ohm,179ohm in calculate the total ohm in series circuit
A low wet bulb temperature indicates
How to arrange a hous hold earthing system to keep minimum earth resistance( below 7ohms).
what should be the ideal gauge of wire (In sq mm) for different loads in Ampere?
What is state space method ? Why its used ? Can it applicable on linear, non-linear, 1st order, higher order, homogeneous, non-homogeneous, open-loop , closed loops , stable & unstable systems ?
what is the meaning of WYE and DELTA in Electric meter?
A system absorbs 100 k J of heat and the increase in its internal energy is 100 kJ; the work done is
what is the main function of capacitors in mccs.
what will happens if one phase is missing for 33/11kv power transfomer and why?
what is sevice settings for mccb?How can be it setted?