how can change 12mmdia@150c/c bar spacing to 16mmdia
Answer Posted / mustafa mohd layeak
Consider 1m strip of slab.
Using 12mm dia bar with a spacing of 150mm,we get
Area of steel=754sqmm/m length.
So if using 16mm dia bar we get a new spacing
s=[(1000*201)/754].therefore new spacing
s=266 mmc/c. therefore use 16mm dia bar@250mmc/c.
But check [M/V + L']>dev length at support.
Is This Answer Correct ? | 26 Yes | 11 No |
Post New Answer View All Answers
sir tell me the formula for calculating the volume of 380mm dia double under reamed pile of 4.0 mts depth.
In foundation design, while we do the base pressure check, we normally check if the attained pressure value is less than the GROSS BEARING CAPACITY of the soil which is the sum of net bearing capacity of soil and the overburden pressure. Actually, the overburden pressure acts against the net bearing capacity of the soil and I feel that we are actually increasing the bearing capacity value and doing the check. I feel that this is NOT right. Please clarify on this.
how to calculate mivan shuttering matrial
what do you mean by yeild stress of a material? What will happen when hit is given to cement?
For Granite Flooring,For Cement Slurry purpose which one is effective of cost control whether OPC or PPC or White cement?
how much concrete solid/hollow block are manufacture per 50 kg cement bag in differnent sizes like 400x200x200mm, 400x200x150mm, 400x200x100mm. And need proper ratio as per sale quantity. pls send my mail mathi7599@gmail.com searching last two years not yet get pls find and enclosed pls. need practical analysis.
1.what type of the rock is most suitable for wet mix macadam in construction of road? 2.what is the highest maximum dry density and optimum moisture content can be acheive by using most suitable crush rock?
What is the difference between linear dimension and aligned dimension?
how to prepare site mix design
plumbing CPVC fitting FTE Brass full form
How do you convert wind speed into force?
What in bending moment, if a moment is free end of cantilever beam?
How much is the cover for slab?
What are the points to be considered for calculating cement reconciliation. a)Do we need to deduct the wt of cement bags b)Do we need to adjust the qty due to wt loss during transportation, loading unloading etc or else each bag can be considered as 50 kg bag c)What is the proportion of mix cover block making.
what is kribs is supporting?