Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / shivam pagare
there are generally 2 types of sockets that we applied in domestic as well as in industrial circuits.
upto 230-240volts(1phase) we used 5amp sockets
and
for above ie. 440volts(3phase) we use 15 amp sockets.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
How To Convert Apparent Into Real Power Without Knowing Reactive Power?
How to Calculate The Neutral Earth flat design calculation for the Synchronised generator (Gen 1-650Kva, Gen 2-725Kva
Give some example of fault limiting devices?
why current is constant on d.c?
A logic circuit that provides a HIGH output if one input or the other input, but not both, is HIGH, is a(n)?
for hipot test on 33kV busbar, we will test on 70 kV or 56kV, what is the acceptable leackage current?
what happen if the parallel generator phase angle shift by 1 degree in manual mode
why the rotor current becomes in steady state during high slip region? please verify with equations.
WHAT IS THE FUNCTION OF SHORT CIRCUIT MAINTENANCE CT
in HT service 3ph 4 wire service Y-phase voltage shows zero . whether it is meter fault? or what be the reason ? if y-ph voltage zero ,can current is recorded? reasons for failure?
Why in ESP Positive earthed
5- What is the task (function) of the excitation and isolation transformers in power plant? 6- What is the task (function) of LCI (A), LCI (B) and LCI (COS) in power plant? : LCI (A) and LCI(B) are load commutating inverter for generator turbine starting. , LCI (COS) is load commutating inverter change over switch
What is measurement?
Mention the disadvantages of low power factor?
If there is major % of Voltage harmonics in the system, how can it be control or reduced?
